Linking the DJI Phantom 3 Remote to the Aircraft

For DJI Phantom 3 Advanced / Professional

Step 1 – Plug a compatible phone or tablet into the remote controller using the USB cable corresponding to your device.

Step 2 – Power on the controller by pressing the power button, releasing, and then press again while holding until the controller boots up.

Step 3 – Launch the DJI Go 4 app on your phone and select Enter Device to enter the camera view.

Step 4 – Once in the camera view select the ••• icon in the top right corner.

Step 5 – Select the transmitter icon from the left side of the menu.

Step 6 – Scroll down to Linking Remote Controller, click it, and select OK.

Step 7 – The remote controller should now give you 60 seconds to power on the aircraft and enter linking mode. To this this begin by powering on the aircraft. To power on the Phantom 3 press the button on the battery, release, and then press again while holding until boot up.

Step 8 – Press the button on the VPS (behind the camera/gimbal) next to the light with a pen or paperclip. The LED should begin to blink until linking is complete.

The transmitter and aircraft should pair automatically after a few seconds. If you have any drone problems feel free to contact Seattle Drone Repair.